Wadia 7 Spécifications télécharger pdf (Page 9)

971CD T ransport

Configuring

The Wadia 971 CD Transport has several functions that can be configured to match your system. You can change

the configurations by using the remote control.

The factory configurations settings will work in all systems. You can begin listening to your Wadia 971

CD Transport without adjusting the configuration settings, then adjust them for maximum performance

at a convenient time.

Configuring the Digital Outputs

You can configure each digital output separately. There are two modes available for each output:

OFF: Turns off the signal from this output, as well as the circuitry used to drive the output. Turning off unused

outputs will result in a small but noticeable improvement in sound quality.

ON: Turns on the signal.

The factory setting is ALL outputs ON.

Clocklink Configuration

There are two ClockLink modes:

ENABLED MODE: In this mode, the Wadia 971 CD Transport will sense whether there is a ClockLink signal

connected. If there is, the Wadia 971 CD Transport will automatically engage ClockLink. If there is no

ClockLink cable connected, the Wadia 971 CD Transport will disengage ClockLink.

DISABLED MODE: In this mode, the Wadia 971 CD Transport will disengage ClockLink even if it is connected

to a ClockLink cable. If your Wadia Decoding Computer does not have a ClockLink output, switching to the

Disabled Mode will result in a slight improvement in sound quality.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

Wadia 7 Spécifications Page 9